|
|
 |
|
 |
| |
| A
new quenched and tempered steel
designed to have high impact and low
residual stresses and therefore good
dimensional stability. |
 |
|
THE
COMPETITION |
| |
 |
 |
| |
Presentations on: |
Toolox44 Tool Testing: |
Toolox44 Application: |
|
|
|
|
|
|
|
|
|
Features:
- Despite
hardness of nominal 45 HRC, this
new steel is easy to
machine.
- Particularly
suitable for manufacturing
plastic molds because it can be
polished and etched with very
good results.
- Great
for guide rails, bending tools,
etc. when high stability materials
are required.
|
|
|
|
|
Toolox 44 is a new
quenched and tempered steel designed to have high
impact resistance and low residual stresses and
therefore good dimensional stability. Despite a
hardness of 45 HRC, the new steel is easily
machined. Toolox 44 is particularly suitable for
manufacturing plastic molds because it can be
polished and etched with very good results. Fields
of application: plastic molds, rubber molds, wear
components and machine components, such as guide
rails, bending tools, etc., where stability
materials are required.
Technical
Information (Typical Values)
|
|
| Hardness |
Hardness
range 41 - 47 HRC |
| Impact
toughness |
| Test
temperature ºF 68
Impact
energy, Charpy-V-test for plate,
direction; Guaranteed minimum Ft. lbs.
14
|
|
| Milling |
At
cutting speed of 140m/mm, feed 0.15mm and
10min effective machining time using Sandvik
Coromil 200 and inserts GC 1025, we
guarantee maximum edge wear of 0.3mm |
| Etching |
Toolox 44 fulfills the etching requirements of NADCA 207-2003 |
| Dimensions |
Toolox 44 is supplied as plate in thickness between
.200" - 5 1/8" |
| Heat
treatment |
Toolox 44 is not intended for further heat
treatments. If Toolox 44 is heated above 590º
C, no guarantees for the properties of the
steel can be given. |
| Nitriding/coating |
Below
temperature <590º C / 1094 ºF |
Toolox
44
can be machined on conventional machines. It is
important that sharp tools are used with a
positive cutting angle and that vibration is
avoided. Use the following recommendations as
guidelines and the starting point for your own
evaluation of best practice.
 |
| |
| Recommended
preheat temperature when gas cutting
and welding Minimum
250º C |
Recommended
stress relief annealing
(after slow cooling to room
temperature ) after gas
cutting
and welding 580º
C |
|
Testimonials
Read what our
customers are saying about Toolox44:
 |
"We
recently tested Toolox 44 from International Mold Steel, Inc., and
are pleased with the exceptional performance versus H-13."
Read complete testimonial. |
|
|
|
|
 International Mold Steel, Inc.
6796 Powerline Drive
Florence, KY 41042 USA
Tel: (859) 342-6000 or 1-800-625-6653
Fax: (859) 342-6006
Sales: salesdesk@imsteel.com
Literature: info@imsteel.com
|
|
|
|
